Front Panel Status Indicators
GREEN LED: ON: Unit powered This lamp is illuminated whenever the IntelliFlow
®
is plugged into
a powered wall outlet.
YELLOW LED:
ON: Water supply Open. This lamp is illuminated whenever the IntelliFlow
®
senses
OFF: Water Supply Closed. current flow (the washing machine is turned on).
It is off when the washing machine is turned off.
NOTE: Some washing machine models include circuitry that
causes a slight current draw at all times. These models when
connected to the IntelliFlow
®
can cause the water supply to be
energized continuously (Yellow LED: ON). The IntelliFlow
®
requires calibration, see page 4 for callibration instructions.
RED LED:
ON: Leak Sensed. This lamp is illuminated when the leak sensor is installed and
water has been detected at the sensor. The water supply to the
washing machine hoses are interrupted when a leak is detected.
BLINKING: Unit Timed Out – This lamp blinks whenever the internal timing circuit has timed
out and has shut off the water supply to the washing machine
hoses. Turning the washing machine Off then On will reset the
timing circuit.
FAINT BLINK: (3-5 seconds) – This condition indicates the leak sensor is unplugged. To provide
the maximum level of protection, it is recommended that the leak
sensor be installed at all times.
7
Sensor Plug
What is Surge Protection?
In many locations, changes in the AC voltage supply to the home by the
electrical utility company can occur. Both lower voltage (brownouts) and
high voltage (surges) can occur. Lightning strikes can also cause high
voltage spikes to occur.
All electronic equipment is designed to operate properly within a
voltage range. However, high voltage surges or spikes can dam-
age sensitive circuitry within electronic equipment.
Surge protectors prevent voltage spikes from reaching
electronic equipment.
What is Ground Fault Protection?
In many locations, an electrical differential between an electrical ground
and a water pipe ground can exist. A person touching both grounds
could receive a shock that may cause injury or death. A ground fault
interrupter circuit (GFI) detects the differential and removes electrical
power before injury can occur.
The IntelliFlow
®
does not cause or change the electrical dif-
ferential that exists.
IS-A2C-M1-A2C-WB-M1.qxd 6/22/09 2:30 PM Page 7
(1 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern